Week 6 Final Year Project 2

Date: 28 February 2018

Time: 3.00 p.m

Place: Library


Objectives:

- To run the temperature and humidity sensor hardware by using the NodeMCU 0.9 ESP-12 Module after the simulation on the Proteus.  


Activities:

- I do the testing the temperature and humidity sensor with NodeMCU 0.9 ESP-12 Module to see how it works. Here the connection of the ESP with the sensor. The pin of (+) connected to 3V of the sensor to the ESP, the pin of (-) connected to the Gnd and the pin (OUT) connected to the D2 (GPI04). The humidity and temperature sensor were detected the parameters in degree Celcius (*C) for temperature and percentage of the humidity (%). The reading were changed when the temperature were high or low and humidity were low or high. 

Here the changes of the temperature and humidity parameters when the sensors were detected. The higher the temperature, the lower the humidity. While the lower the temperature, the higher the humidity. But, some cases the humidity is high with the temperature are remain same or unchanged. So, based on the testing hardware the sensor were working successful to detect the humidity and temperature parameters.